FeedV2 is a VCA with with an integrated EQ. It is being designed as some kind of
voltage controlled aux send module. The new version V2 has an improved Tone response
and its horizontal pitch has been reduced from 8HP to 4HP.
If you insert an audio source into the jacks IN it will be directly routed to the
THRU jack where you may use you original signal for further processing.
The signal is also directly routed to the VCA. Here you can control the volume or
amplitude of the audio either manually or via control voltage using the CV jack.
Additionally you may change the frequencies of the signal using the TONE potentiometer.
Turning counterclockwise will add low and cut high frequencies und turning the knob
clockwise will cut low and boost high frequencies.
This works well with drums that will be send to an delay, reverb or any other effect
when control voltage is being send to the CV jack.
Voltag Controlled Amplifier
Built in EQ
Original signal is routed to THRU out
Wrong polarity protection
3U Eurorack module, 4 HP wide
Power consumption: 30 mA at +12 V and 12 mA at -12 V