Voltag Controlled Amplifier Volume Control CV Attenuator Built in EQ Original signal is routed to THRU out Wrong polarity protection Skiff friendly 3U Eurorack module, 4 HP wide Power consumption: 30 mA at +12 V and 12 mA at -12 V

The module consists of two boards:

Front PCB Panel Main PCB


4HP VCA with integrated EQ

It has been designed as some kind of voltage controlled aux send module. The new version V2 has an improved Tone response and its horizontal pitch has been reduced from 8HP to 4HP. If you insert an audio source into the jacks IN it will be directly routed to the THRU jack where you may use you original signal for further processing. The signal is also directly routed to the VCA. Here you can control the volume or amplitude of the audio either manually or via control voltage using the CV jack. Additionally you may change the frequencies of the signal using the TONE potentiometer. Turning counterclockwise will add low and cut high frequencies und turning the knob clockwise will cut low and boost high frequencies. This works well with drums that will be send to an delay, reverb or any other effect when control voltage is being send to the CV jack.