Emoo

8HP Eurorack Adapter Module for some of the MOOER Guitar Effect Pedals

The PCB set consists of a little adapter PCB with a 12V to 9V voltage regulator and the IN and OUT jacks (3.5mm). Additionally there is a Panel PCB that fits most of the little MOOER effect pedals (those with the potentiometers and switches arranged as shown in the graphic on the left). You need to buy the original MOOER pedal in order to use this module in your eurorack setup. It is not recommended to use MOOER pedals that use a tap button (instead of a standard LED) or a momentary foot switch (such as the “EchoVerb” pedal). The diameter of the tap button will not fit the hole in the panel and the momentary foot switch is not connected to the MOOER PCB, thus not giving any hold to the EMOO panel. If you feel adventurous though, you can enlarge the hole on the panel yourself and attach the MOOER PCB to the panel with a little screw. You need to be able to drill properly in order place the holes correctly. There is a description of the drilling procedures available on the ST Modular Github Repository. The adapter PCB may be used with any other guitar pedal requiring a 9V power supply. In this case you need to make the panel yourself. Version 2 now has a gain stage on the output. You may not only adjust the input level, but also the output gain to modular levels via trimmer on the PCB.

Details:

Use most of your MOOER EFX pedals in your modular setup Easy plug and play without dealing with adapter cables Use your Eurorack power supply unit to power your little MOOER pedal Passive Volume Trimmer to reduce Eurorack synth-levels on the back of the PCB Active Output Gain on PCB V2 to increase effect level to modular level Skiff friendly Wrong polarity protection 3U Eurorack module, 8 HP wide Power consumption depends on the pedal you choose (from 3mA to 160mA; Sky Verb approx. 130mA)

The module consists of two boards:

Front PCB Panel Small Adapter PCB
NEXT NEXT
ST MODULAR 2019 - INFO@ST-MODULAR.COM